Got a new tape drive. IBM 3581 connect to my Solais 9 880,
works well but Sybase no likey. any ideas ? When I look at
the sense data from my scsi device, I see where no block
size is set and defaults to 0, I can set it but that value
does not hold to sybase. I can tar to the tape all day

tape list devices are
/dev/rmt/4stn, 4stcn, 4stcbn, 4stcb, 4stc, 4stbn, 4stb, 4st

1> dump database CATS_DEV
2> to '/dev/rmt/4stcbn'
3> blocksize=4096, capacity=18874368
4> with init, nounload
5> go
Backup Server session id is: 141. Use this value when
executing the
'sp_volchanged' system stored procedure after fulfilling any
volume change
request from the Backup Server.
Backup Server: Device /dev/rmt/4stcbn may not be
used: minimum
blocksize for I/O exceeds device maxiumum of 0.
Msg 8009, Level 16, State 1:
Server 'PSCN', Line 1:
Error encountered by Backup Server. Please refer to Backup
Server messages for