New to ASM, I added 1 disk to ASM on Sunday and thought if I didn't specify a rebalance it wouldn't run. Then when I went to add more disks this week I would run a rebalance at power 11. What happens however is it kicks off with default power 1. Now our SA has informed me 10 more disks are configured and ready to be added to ASM but the rebalance is apparently only half done. How can I stop this rebalance operation so I can add the new disks then kick it off again? Thanks!
Alternatively, if the ASM rebalance operation cannot be stopped can I set the ASM_POWER_LIMIT higher to say 11 to make the rebalance of the existing running operation go faster or will that just affect any operation started after the power limit was set?